Free shipping on orders over
Free shipping over

Shopping Cart

MLT Leveling System Thin Tile Base Plates

$53.25 $26.63

Categories :

MLT Leveling System Thin Tile Base Plates

MLT Thin Tile Base Plates are designed with thin tiles less than 1/4″ thick. They allow for excellent thin-set coverage on both walls and floors and can be used with any thin porcelain or ceramic tile.

Features

  • Base Plates for thin porcelain and ceramic tile
  • Ready to use, no pre-soaking required
  • Use tiles less than 1/4″ thick to guarantee perfect alignment and plane during the curing of the setting material
  • Pre-assemble Thin Tile Base Plate to reusable MLT Strap (sold separately) before use
  • Counter sinkholes assist in adhesion for ceiling tile applications
  • Engineered specifically for thin tiles to ensure maximum thin-set coverage without hollow spots
  • MLT Base Plates are available in three other styles to accommodate all types of materials: Porcelain Tile Base Plates, Offset/Plank Tile Base Plates, and Stone Base Plates

MLT System Installation

  • Pre-assemble reusable connecting tab and base plate
  • Push the stainless steel portion of the re-usable connecting tab through the center opening of the selected base plate
  • Align protuberances by passing them entirely through the slotted openings of the stainless steel connecting tab
  • Pull the connecting tab until the “snap lock” engages
  • The base plate should remain affixed to the re-usable connecting tab unless separation is desired
  • Insert pre-assembled, re-usable connecting tab and base plate under the tile or stone edge, sliding the connecting tab’s base plate under the tile or stone being installed, at approximately 3 from the corners (MLT System components may be used for the corners of offset pattern, in the T intersection of porcelains having a minimum thickness of 3/8)
  • The spacing of each re-usable connecting tab should not exceed 20 to 24 apart, during installation
  • Do not place them under a four-corner junction, as lippage may result and also significantly increase the difficulty of producing a straight grout joint line
  • Once the pre-assembled, re-usable connecting tab and base plate are in place, proceed using standard installation procedures
  • Upon completing the “set” of the tile or stone, lower the tension locking cap over the re-usable connecting tab to the tile or stone surface, then slide the cap in the direction of the grout joint to engage the lock
  • Place the installation/removal tool atop the tension locking cap to engage the re-usable connecting tab and tension MLT System to create a lippage-free surface
  • If additional cleaning of the grout joint line is required after the MLT System has been tensioned, remove the cap, clean the joint line, re-engage the cap, and re-tension
  • To remove the set tension setting dial on S for Snap
  • Place the installation/removal tool atop the re-usable cap and engage the re-usable connecting tab
  • Collect and store all re-usable connecting tabs and re-usable tension locking caps for future use
  • When using the MLT System for installations of thin tile, un-glazed, or highly polished materials, it is strongly recommended to use the fitted Rubber Pad accessory under the re-usable tension locking cap
Add a Review

Your email address will not be published. Required fields are marked *

Related Products